UniFi 60W Power Supply Wall Mount – PSU Model E060-1D540110VU – Ventilated, Wall-Mountable

🔌 Wall Mount for UniFi 60W Power Supply

Compatible PSU Model: E060-1D540110VU

This custom wall mount is designed specifically for the UniFi 60W power supply model E060-1D540110VU, commonly included with UniFi’s smaller switches.

Instead of leaving the power brick on the floor, hanging by the cord, or shoved behind equipment, this mount lets you secure it to the wall cleanly—while keeping airflow exactly where it should be.

⚠️ Designed to be used with a short power extension cord so the PSU can be mounted without stressing the plug or cable.

⸻

🔍 CHECK YOUR POWER SUPPLY (IMPORTANT)

Before ordering, please verify your PSU label.

This mount is compatible ONLY with the following power supply:
• Model: E060-1D540110VU
• Input: 100–240V ~ 50/60Hz 1.5A
• Output: 54.0V ⎓ 1.1A
• Rated Power: 60W

👉 If your label does not match this model number, this mount will not fit.

(Photos show exactly where to find the model number on the PSU.)

⸻

✅ FEATURES & DESIGN DETAILS

✔ Custom-fit for UniFi 60W PSU E060-1D540110VU
✔ Open-sided design for proper ventilation (heat can escape freely)
✔ Wall-mount ready with built-in screw holes
✔ Wide, flat rear surface allows use of double-sided tape
✔ Secure retention tabs keep the PSU in place while allowing easy removal
✔ No sharp bends or cable strain

In other words: it holds the brick, lets it breathe, and keeps your setup looking intentional instead of “network spaghetti.”

⸻

🛠 INSTALLATION OPTIONS
• Screw mount to drywall, wood, cabinets, or backing boards
• Double-sided mounting tape compatible (not included)

⚠️ If using tape, choose a high-quality mounting tape rated for the PSU’s weight.

⸻

📦 WHAT’S INCLUDED
• 1× Wall Mount for UniFi 60W PSU (Model E060-1D540110VU)

Not included:
Power supply, extension cord, screws, or mounting tape.

⸻

⚠️ PLEASE NOTE
• Compatible only with UniFi 60W PSU model E060-1D540110VU
• Open design is intentional to allow proper ventilation
• Minor surface imperfections are normal due to the 3D printing process
• This is a custom accessory and is not affiliated with or endorsed by Ubiquiti

⸻

💡 WHY BUY FROM ME?

✔ Consistent Etsy Top Seller – Month after month with a 5.0-star rating
✔ Designed by someone who actually runs UniFi gear
✔ Made to order with high-quality 3D printing
✔ Clean, practical designs—no fluff
✔ Fast response if you have questions or need help verifying compatibility

Materials: PETG.